Fastener Tightening Specifications
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
| Component | Fastener Size | Nm |
|---|---|---|
| ABS Wheel Speed Sensor to Wheel Bearing Housing Bolt | - | 9 |
| Coupling Rod to Stabilizer Bar Bolt 1, 2 | - | 40 + 90° |
| Coupling Rod to Subframe Bolt 1, 2 | - | 40 + 90° |
| Cover Plate to Wheel Bearing Housing Bolt | - | 10 |
| CV Joint Boot Clamp | - | 20 |
| Drive Axle to Final Drive Bolt 1 | M10 | 70 |
| Drive Axle to Wheel Hub Bolt 1 | - | 200 + 180° |
| Lower Transverse Link to Subframe Bolt 1, 2 | - | 70 + 180° |
| Lower Transverse Link to Wheel Bearing Housing Bolt 1, 2 | - | 120 + 360° |
| Shock Absorber to Mount Nut 1 | ||
| - Conventional | - | 35 |
| - Electronic Damping | - | 50 |
| Shock Absorber to Wheel Bearing Housing Bolt 1, 2 | - | 150 + 180° |
| Shock Absorber Mount to Body Bolt 1 | - | 50 + 90° |
| Stabilizer Bar to Subframe Bolt 1 | - | 25 + 90° |
| Subframe to Body Bolt 1 | - | 115 + 90° |
| Tie Rod to Subframe Nut 1 | - | 95 |
| Tie Rod to Wheel Bearing Housing Bolt 1, 2 | - | 90 + 90° |
| Upper Transverse Link to Subframe Bolt 1, 2 | - | 70 + 180° |
| Upper Transverse Link to Wheel Bearing Housing Nut 1, 2 | - | 95 |
| Wheel Hub to Wheel Bearing Housing Bolt 1 | ||
| - FWD | - | 200 + 180° |
| - AWD | - | 80 + 90° |
|
||