Tie Rod, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
A vehicle with air suspension is described in the work procedure.
-- Remove the rear wheel, refer to WHEELS AND TIRES .
-- Loosen the wheel housing liner in the front area, refer to Wheel Housing Liner and push to the side.
-- Remove the bolt -4- first.
-- Mark installation position of the eccentric bolt -1- to the subframe -2-.
-- Remove the nut, the eccentric washer and the eccentric bolt -1-.
-- Remove the tie rod -5-.
NOTE:
Ignore item -3-.