Overview - Windshield
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- On vehicles equipped with lane assist, the camera must be recalibrated if the windshield has been replaced. Refer to Driver Assistance Systems Front Camera .
- The Windshield Projection Head Up Display Control Module -J898- must be calibrated if the windshield on a vehicle with windshield projection is replaced. Refer to [For engine(s) CTUA, CEUC, CRDB, CGXB, CPNB] Removal and Installation .
- Windshield
- Distance to roof dimension -a- = 2 mm.
- Align the side distance -c-.
- Adhesive Bead
- Observe the minimum curing time. Refer to MINIMUM CURING TIME FOR BONDED WINDOWS .
- Dimension -b- = 17 mm ± 2 mm
- Dimension -d- = 8 mm ± 2 mm
- Dimension -e- = 12 mm± 2 mm
- Observe the minimum curing time. Refer to MINIMUM CURING TIME FOR BONDED WINDOWS .
- Gap Cover
- No replacement part
- Drip Rail
- Plenum Chamber Cover Frame
- No replacement part
- With a new window, the protective piping must first be removed before installing the plenum chamber cover. Refer to Fig 3.
- Plenum Chamber Cover
- Press into retaining strip only after window adhesive minimum curing time is complete (3 hours).
before ordering a new windshield on vehicle version with a Driver Assistance Systems Front Camera -R242- the version must be determined.
| -A- | Retaining plate for the Driver Assistance Systems Front Camera -R242- older version → windshield older version allocation |
| -B- | Retaining plate for the Driver Assistance Systems Front Camera -R242- newer version → windshield newer version allocation |
-- With a new windshield -1-, protective piping -2- must be removed from molding -3- before installing plenum chamber cover -4-.