Side Window, Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Installing. Refer to BONDED WINDOW GLASS INSTALLATION INSTRUCTIONS .

-- Prepare the undamaged window for installing. Refer to UNDAMAGED WINDOW GLASS, PREPARING FOR INSTALLATION .

-- Prepare the new window for installation. Refer to NEW WINDOW GLASS, PREPARING FOR INSTALLATION .

-- Prepare the body flange for installation. Refer to BODY FLANGE, PREPARING FOR INSTALLATION .

NOTE:

1K Window Adhesive DH 009 100 03 (small cartridge) is recommended when bonding a single window 2K Window Adhesive KitD 004 600 A2 is recommended when bonding more than one window.

-- First press the new window onto the >>D-pillar<< with the securing pin, then insert it into the window opening and push the securing pin onto the >>C-pillar<<.

-- On windows without a securing pin, align the window lengthwise to the edge on the side panel -arrow- and then insert it into the cut-out for the window.

Fig 1: Aligning Window Lengthwise To Edge On Side Panel -Arrow-

Courtesy of AUDI OF AMERICA, LLC

-- Secure window in window opening with adhesive tape.

-- Install the door seal on the >>B-pillar<<.

-- Observe the minimum curing time. Refer to MINIMUM CURING TIME FOR BONDED WINDOWS .