Brake Rotor, Removing And Installing : Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
-- Raise the vehicle.
-- Remove the wheels.
-- Unclip the wire from the brackets on the stub axle carrier.
-- Remove the bolts -12-.
-- Remove the brake caliper with the brake pads and the brake carrier -11-.
-- Hang the brake caliper with the brake carrier on the body with wire.
CAUTION:
Do not let the brake caliper with the brake carrier hang on the brake hose. Do not support the weight with the brake hose.
WARNING:
Do not actuate the brakes or the electromechanical parking brake when the brake caliper is removed.
-- Remove the securing bolt -arrow- on the brake rotor while holding the rotor firmly.
-- Remove the brake rotor from the wheel hub.
NOTE:
When removing the brake rotor from the wheel hub, do not tilt the brake rotor.