Brake Pad Wear Display Wire, Removing And Installing : Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Install the clip for the brake pad wear contact in the inner brake pad.

-- Install the contact in the clip direction of -arrow-.

Fig 1: Identifying Contact

Courtesy of AUDI OF AMERICA, LLC

NOTE: Make sure the contact for the brake pad wear display fits correctly in the clip inside the inner brake pad.

-- Connect wear indicator connector.

-- Install the electrical connection for the brake pad wear display in the bracket.

-- Install the wheels. Refer to Wheel and Tire Guide Wheels, Tires, Wheel Alignment .

-- Lower vehicle.