Brake Pad Wear Sensor, Removing And Installing : Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the affected rear wheel. Refer to Wheels, Tires, Wheel Alignment .
-- Disconnect the brake pad wear sensor connector -1-.
-- Release the connector -2- to the brake pad wear sensor from its bracket -arrow B- while turning it 90° at the same time -arrow A-.
-- Remove the dust cap -3- from the bleed screw and free up the electrical wire.
-- Remove the brake pad wear sensor contact -4- with pliers.