Brake Pad Wear Sensor, Removing And Installing : Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
-- Insert the new contact -1- for the brake pad wear sensor into the inner brake pad until it engages.
NOTE:
Make sure that the brake pad wear sensor contact fits correctly in the brake pad.
-- Secure the electrical wire for the brake pad wear sensor with the dust cap -2- as shown.
-- Bring the connector -3- into its installed position and turn in direction of the -arrow- until the tab -4- engages in the hole -5- on the bracket.
-- Assemble connector -6-.
-- Install the rear wheel. Refer to Wheels, Tires, Wheel Alignment .