Rear Brake Rotor, Removing And Installing : Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
- Tightening specifications. Refer to OVERVIEW - REAR BRAKES .
NOTE:
Ceramic Brake Rotor, determining wear. Refer to CERAMIC BRAKE ROTOR, DETERMINING WEAR .
Always replace brake rotors on both sides of the axle.
When installing brake rotors, pay attention to the arrow showing the direction of travel and to the left and right installed location.
WARNING:
Do not blow out the brake caliper with compressed air.
-- Thoroughly clean the brake rotor and hub contact surfaces.
-- Tighten the bolt -1-.
NOTE:
Ignore the -arrows-.
-- Install the brake caliper. Refer to Installing . For brake pads. Refer to Installing ).
WARNING:
Make sure the brakes are working correctly before driving the vehicle for the first time.
After installing, press the brake pedal several times firmly to properly seat brake pads in their normal operating position.
Check brake fluid level, and fill if necessary.