Brake Pad Wear Sensor, Removing And Installing : Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the affected front wheel. Refer to Wheels, Tires, Wheel Alignment .

-- Disconnect the brake pad wear sensor connector -2-.

Fig 1: Identifying Connector To Brake Pad Wear Sensor

Courtesy of AUDI OF AMERICA, LLC

-- Release the connector -1- to the brake pad wear sensor from its bracket -arrow A- while turning it 90° at the same time -arrow B-.

-- Free up the brake pad wear sensor electrical wire -3- by opening the dust cap -2- and unclip it from the brake caliper -arrow-.

Fig 2: Identifying Brake Pad Wear Sensor Electrical Wire And Dust Cap

Courtesy of AUDI OF AMERICA, LLC

-- Remove the brake pad wear sensor contact -1- from the brake pad with pliers.