Brake Pad Wear Sensor, Removing And Installing : Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Brake Pad Wear Sensor Electrical Wire And Dust Cap

Courtesy of AUDI OF AMERICA, LLC

-- Insert the brake pad wear sensor contact -1- in the brake pad until it engages.

NOTE: Make sure that the brake pad wear sensor contact fits correctly in the brake pad.

-- Secure the brake pad wear sensor electrical wire -3- by guiding it on the brake caliper -arrow- and securing it with the dust cap -2- as shown.

-- Bring the connector into its installed position and turn in direction of the -arrow- until the tab -1- engages in the hole -2- on the bracket.

Fig 2: Identifying Tab

Courtesy of AUDI OF AMERICA, LLC

-- Connect the electrical connector -3-.

-- Install the front wheel. Refer to Wheels, Tires, Wheel Alignment .