Brake Pad Wear Indicator, Removing And Installing : Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Raise the vehicle.

-- Remove the wheels.

-- Disconnect the connector for the brake pad wear display -arrow-.

Fig 1: Disconnecting Brake Wear Indicator Connector

Courtesy of AUDI OF AMERICA, LLC

-- Release the connector from the mount while turning it 90° at the same time.

Fig 2: Releasing Connector From Retainer Using Screwdriver And Simultaneously Turning Connector 90Degrees

Courtesy of AUDI OF AMERICA, LLC

-- Remove the connector from the bracket.

-- Remove the contact form the clip inside the inner brake pad.

-- Remove the clip from the inner brake pad.