Brake Caliper, Removing And Installing : Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Do not loosen the bolted connections -A and B arrows-.

Fig 1: Do Not Loosen The Bolted Connections

Courtesy of AUDI OF AMERICA, LLC

WARNING:

There is a risk of malfunction.

Do not loosen the bolted connections -A arrows-
Do not loosen the guide pins -arrows B-.

-- Remove the wheels.

NOTE: When removing, mark brake pads that will be used again. Install in the same position, otherwise braking effect will be uneven.

-- Remove the wheels.

-- Disconnect the connector for the brake pad wear display -arrow-.

Fig 2: Disconnecting Brake Wear Indicator Connector

Courtesy of AUDI OF AMERICA, LLC

-- Release the connector from the mount while turning it 90° at the same time.

Fig 3: Releasing Connector From Retainer Using Screwdriver And Simultaneously Turning Connector 90°

Courtesy of AUDI OF AMERICA, LLC

-- Remove the connector from the bracket.

NOTE:

For easier removal of the brake caliper from the brake rotor, push the brake pads -3- back lightly with pliers -1-. To prevent damage to the coating on the brake caliper, place a piece of rubber -2- or similar between the pliers and brake caliper. Do not damage the existing brake pad wear indicator cable.

Fig 4: Identifying Brake Pads

Courtesy of AUDI OF AMERICA, LLC

-- Remove the brake caliper bolts -11-.

Fig 5: Identifying Front Brake Components

Courtesy of AUDI OF AMERICA, LLC

NOTE: Loosen the bolts -11- with the Socket - Xzn 9T50036.

CAUTION: Remove only these bolts -11- for removing the brake caliper.

NOTE: Do not loosen the brake hose.

-- Pull the brake caliper from the brake rotor.

-- Hang the brake caliper on the body using a suitable wire.

CAUTION: Do not let the brake caliper hang on the brake hose.