Brake Rotor, Removing And Installing : Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Replace the screws.

NOTE: Pay attention to the left or right installed locations when installing the brake rotors.

-- Place the brake rotor on the hub.

NOTE: Do not tilt the brake rotor when mounting it on the wheel hub.

-- Install the screw -19- and tighten it to 9 Nm.

Fig 1: Identifying Front Brakes Overview

Courtesy of AUDI OF AMERICA, LLC

-- Install the brake caliper with brake carrier. Refer to Installing .

-- Install the brake line in the bracket.

Make sure the brake hose is routed correctly. Make sure the brake hose is not blocked, bent or rubbing against the vehicle.

-- Connect wear indicator connector.

NOTE: Make sure the contact for the brake pad wear display fits correctly in the clip inside the inner brake pad.

Fig 2: Identifying Contact

Courtesy of AUDI OF AMERICA, LLC

-- Install the electrical connection for the brake pad wear display in the bracket.

-- Install the wheels. Refer to Wheel and Tire Guide Wheels, Tires, Wheel Alignment .

-- Lower vehicle.

WARNING:

Make sure the brakes are working correctly before driving the vehicle for the first time.

After installing, press the brake pedal several times firmly to properly seat brake pads in their normal operating position.

Check brake fluid level, and fill if necessary.