Brake Caliper, Replacing : Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Insert the Brake Pedal Actuator VAG 1869/2 between the brake pedal and driver seat and press the brake pedal at least 60 mm. By doing this, the valves in the brake master cylinder are closed and the brake fluid reservoir does not run empty.

Fig 1: Brake Pedal Depressor VAG 1869/2 Inserted Between Brake Pedal And Driver's Seat

Courtesy of AUDI OF AMERICA, LLC

-- Raise the vehicle.

-- Remove the wheels.

-- Connect the hose from a bleeder bottle to a brake caliper bleed screw -2-.

Fig 2: Identifying Front Brakes Overview

Courtesy of AUDI OF AMERICA, LLC

-- Open a brake caliper bleed screw on the front brake caliper to reduce the pressure from the brake system.

WARNING: When working with brake fluid, observe relevant safety precautions and notes. Refer to BRAKE FLUID .

-- Close the bleed screw.

NOTE: Do not remove the Brake Pedal Actuator VAG 1869/2.

-- Remove the brake line -18- from brake caliper.

Fig 3: Identifying Front Brakes Overview

Courtesy of AUDI OF AMERICA, LLC

-- Remove the brake pads. Refer to Removing .

NOTE:

When removing, mark brake pads that will be used again. Install in the same position, otherwise braking effect will be uneven.

The brake rotor is secured with a bolt.