Brake Caliper, Replacing : Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Install the brake pads. Refer to Installing .

Replace any damaged guide pins.

Make sure the brake hose is routed correctly. Make sure the brake hose is not blocked, bent or rubbing against the vehicle.

-- Install the brake line -18- in the brake caliper and tighten it to 20 Nm.

Fig 1: Identifying Front Brakes Overview

Courtesy of AUDI OF AMERICA, LLC

-- Install the brake line in the bracket.

-- Connect wear indicator connector.

-- Install the electrical connection for the brake pad wear display in the bracket.

NOTE: Make sure the contact for the brake pad wear display fits correctly in the clip inside the inner brake pad.

Fig 2: Identifying Contact

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Brake Pedal Actuator VAG 1869/2.

NOTE: Only bleed the brakes on the wheel which the brake caliper and the brake line was separated. If the brake pedal still feels "soft", completely bleed the brakes. Refer to BRAKE SYSTEM, BLEEDING .

-- Refer to BRAKE SYSTEM, BLEEDING

-- Install the wheels. Refer to Wheel and Tire Guide Wheels, Tires, Wheel Alignment .

-- Lower vehicle.

WARNING:

Make sure the brakes are working correctly before driving the vehicle for the first time.

After installing, press the brake pedal several times firmly to properly seat brake pads in their normal operating position.

Check brake fluid level, and fill if necessary.