Brake Rotor, Removing And Installing : Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Clean the brake rotor, wheel hub and contact surfaces before installing.
-- Place the brake rotor on the hub.
NOTE:
When positioning the brake rotor, do not tilt it on the wheel hub.
-- Install the securing bolt -arrow- and tighten.
-- Install the brake caliper with the brake pads and front brake carriers.
-- Install the wheels.
Wheel bolt tightening specifications. Refer to Wheels, Tires, Wheel Alignment .
-- Lower the vehicle.
WARNING:
Make sure the brakes are working correctly before driving the vehicle for the first time.
After installing, press the brake pedal several times firmly to properly seat brake pads in their normal operating position.
Check brake fluid level, and fill if necessary.