Brake Caliper, Replacing : Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
The four retaining pins for the brake pads on the brake carrier must not be loosened under any circumstances.
-- Insert the Brake Pedal Actuator VAG 1869/2 between the brake pedal and driver seat and press the brake pedal at least 60 mm. By doing this, the valves in the brake master cylinder are closed and the brake fluid reservoir does not run empty.
-- Raise the vehicle.
-- Remove the wheels.
-- Connect the hose from a bleeder bottle to one of the bleeder screws on the front caliper.
-- Open a bleeder screw on the front brake caliper to reduce the pressure from the brake system.
WARNING:
When working with brake fluid, observe relevant safety precautions and notes. Refer to BRAKE FLUID
.
-- Close the bleed screw.
NOTE:
Do not remove the Brake Pedal Actuator VAG 1869/2.
-- Remove the brake pressure line from the brake caliper.
-- Brake pads, removing.
NOTE:
When removing, mark brake pads that will be used again. Install in the same position or braking effect will be uneven.
-- Remove the brake caliper -7- from the vehicle.
CAUTION:
Never remove bolts -6 and 9-
-- Remove the bolts -3- on the brake carrier while holding the carrier securely.
-- Remove the brake carrier.