Brake Caliper, Replacing : Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Use new bolts.
-- Position the brake carrier.
-- Secure the brake carrier with new bolts -3-.
-- Install the brake pads.
NOTE:
After replacing the brake pads, press the brake pedal firmly several times while the vehicle is stationary so that the brake pads are seated properly in their normal operating position.
-- Install the brake pressure line -5- in the brake caliper and tighten.
-- Remove the Brake Pedal Actuator VAG 1869/2.
NOTE:
Only bleed the brakes on the wheel which the brake caliper and the brake line was separated. If the brake pedal still feels "soft", completely bleed the brakes. Refer to BRAKE SYSTEM, BLEEDING
.
-- Refer to BRAKE SYSTEM, BLEEDING
-- Install the wheels.
Wheel bolt tightening specifications. Refer to Wheels, Tires, Wheel Alignment .
-- Lower the vehicle.
WARNING:
Make sure the brakes are working correctly before driving the vehicle for the first time.
After installing, press the brake pedal several times firmly to properly seat brake pads in their normal operating position.
Check brake fluid level, and fill if necessary.