Brake Caliper With Brake Carrier, Removing And Installing : Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Use new bolts.
-- Carefully press the brake caliper with the brake carrier and the installed brake pads over the brake rotor.
-- Tighten the brake carrier with new bolts -1-.
-- Insert the brake hose in the bracket -4-.
-- Insert the electric wire in the bracket -2- and lock it to the right -B-.
-- Install the wheels.
Wheel bolt tightening specifications. Refer to Wheels, Tires, Wheel Alignment .
-- Lower vehicle.
WARNING:
Make sure the brakes are working correctly before driving the vehicle for the first time.
After installing, press the brake pedal several times firmly to properly seat brake pads in their normal operating position.
Check brake fluid level, and fill if necessary.