Front Brake Pads, Removing And Installing : Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Do not loosen the bolted connections -A arrows-
Tighten the guide pins -B arrows- to 21 Nm to 26 Nm.
WARNING:
There is a risk of malfunction.
- Do not loosen the bolted connections -A arrows-
- Tighten the guide pins -B arrows- to 21 Nm to 26 Nm.
-- Remove the affected brake caliper. Refer to Removing .
-- Remove the brake pad wear sensor. Refer to Removing .
NOTE:
When removing, mark brake pads that will be used again. Install in the same position, otherwise braking effect will be uneven.
-- Remove the brake pads -1 and 2- in succession from the guide pins -arrows-.
Tighten the guide pins -arrows- to 21 Nm to 26 Nm.
-- If the brakes pads are replaced, then the brake pad springs must also be replaced. To do this, pry the brake pad springs -1 and 2- out of the brake caliper with a screwdriver -arrows-.