Electromechanical Parking Brake Control Module -J540-, REMOVING AND INSTALLING: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
-- Connect the connector -2- to the Electromechanical Parking Brake Control Module -J540-.
-- Slide the retainer on the connector back and lock it.
There may be an additional bracket for other control modules, depending on the engine.
The Electromechanical Parking Brake Control Module -J540- is clipped in under the bracket.
In this case the bracket must be installed. Nuts on the bracket 3 Nm.
-- Insert the control module.
-- Install the nuts and tighten to 3 Nm.
-- If the electronic parking brake control module is replaced, select the "Replace" function for the respective control module in "Guided Fault Finding".
Use the Vehicle Diagnostic Tester.