Mount, Removing And Installing, Brake Booster Push Rod: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
-- Move the seat all the way back as far as it will go.
-- Turn off the ignition.
-- Remove the storage compartment under the instrument panel on the driver side. Refer to Interior Equipment .
-- Remove the footwell vent.
-- Disconnect the connector to the Brake Lamp Switch -F-.
WARNING:
If possible, leave the brake pedal stop installed; it could break the mount for the Brake Lamp Switch -F- if the brake pedal is released too quickly.
-- Remove the Brake Lamp Switch -F-. Refer to Brake Lamp Switch -F-, REMOVING AND INSTALLING .
-- Separate the brake pedal from the brake booster. Refer to BRAKE PEDAL AND BRAKE BOOSTER, DISCONNECTING AND CONNECTING .
WARNING:
If possible, leave the brake pedal stop installed; it could break the mount for the Brake Lamp Switch -F- if the brake pedal is released too quickly.
-- Pry the brake booster push rod mount -12- out of the brake pedal using a suitable tool.