Brake Pedal, Removing And Installing, Vehicles With Automatic Transmission: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Install the brake pedal in the pedal bracket.

-- Remove the bolt -5- through the brake pedal -2- and bracket -4-.

Fig 1: Brake Pedal, Removing And Installing Overview

Courtesy of AUDI OF AMERICA, LLC

-- Install both clips -1- on the bolt.

NOTE:

Make sure the left and right clips -1- fit securely inside the groove on the bolt.

Fig 2: Brake Pedal, Removing And Installing Overview

Courtesy of AUDI OF AMERICA, LLC

-- Install the bolt -3- and tighten to 8 Nm.

Brake Pedal, Attaching to Brake Booster

-- Hold the ball head of push rod in front of the mount and push the brake pedal in direction of brake booster, so the ball head locates audibly.

-- Install the Brake Lamp Switch -F-. Refer to Brake Lamp Switch -F-, REMOVING AND INSTALLING .

-- Install the footwell vent.

Check the function of the Brake Lamp Switch -F- after installing it and before driving the vehicle.

CAUTION: Make sure the brakes are working correctly before driving the vehicle.