Brake System Vacuum Pump -V192-, REMOVING AND INSTALLING, HYBRID VEHICLES: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Air Intake Grilles

GWWA63-10382

Courtesy of AUDI OF AMERICA, LLC

-- Remove the right air intake grille -1- from the bumper cover -arrow-.

-- Remove the air guide hose from the charge air cooler by loosening the hose clamp -1-.

Fig 2: Identifying Air Guide Hose

GWWA21-10233

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -arrows A and B-.

-- Move the air guide hose to the side.

-- Remove the bolts -arrows-.

Fig 3: Identifying Connector & Vacuum Hose

GWWA47-10099

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Brake System Vacuum Pump -V192-. Disconnect the connector -2- and the vacuum hose -1- at the same time.

-- Free up the connector -2- on the bracket.

Fig 4: Identifying Brake System Vacuum Pump -V192- & Bracket

GWWA47-10100

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -arrows- and then remove the Brake System Vacuum Pump -V192- from the bracket.