Overview - FLANGING Tool
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
- Flanging Tool Upper Section
- Remove to change Clamp Jaws
- Hand Grip Mount
- Must be removed to reach retaining screw for upper part
- Screw
- For flanging tool upper section
- Clamp Jaws Threaded Pins
- Center and hold the Clamp Jaws
- 2 mm hex socket head
- Clamp Jaws
- Various
- Assembly instructions. Refer toFig 2
- VAS6056/6 (dark) for black brake lines
- VAS6056/7 (light) for green brake lines
NOTE:
The arrow on the rounded side of the flaring jaws must face toward edge of housing and the straight side of the flaring jaws must be installed toward spindle, otherwise flared head will not be formed correctly.