Brake Caliper Piston, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
-- Force piston from brake caliper housing, one at a time, using compressed air.
Only one piston can be pressed out at a time. Secure opposite piston in brake caliper housing using piston resetting tool -a-. Block the other pistons, for example, using wooden blocks -b-. In addition, place a wooden board -c- in front of the piston resetting tool so that the piston will not be damaged when pressed out.
-- Remove the seal with the Trim Removal Wedge 3409.
When removing, make sure that surface of cylinder is not damaged.