Overview - Brake Caliper
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Install complete repair kit when servicing.
Apply thin coat of Assembly Paste G 052 150 A2 to brake cylinders, pistons and seals.
- 1 -
Bolt
- 30 Nm
- 2 -
Protective Cap
- Insert in brake caliper
- Replacing. Refer to CAP AND GUIDE PIN, REPLACING .
- 3 -
Guide Pin
- Slide through the boot
- Replacing. Refer to CAP AND GUIDE PIN, REPLACING .
- 4 -
Protective Cap
- Install on the bleeder valve.
- 5 -
Bleeder Valve
- 15 Nm
- Apply a thin coat of Assembly Paste G 052 150 A2 to the threads before screwing in.
- 6 -
Brake Caliper Housing
- 7 -
Spring
- Ensure installation position is correct.
- 8 -
Protective Cap
- Do not damage when installing piston
- Coat with Assembly Paste G 052 150 A2.
- 9 -
Piston
- Apply thin coat of Assembly Paste G 052 150 A2 to piston before inserting
- Diameter 57 mm.
- Removing and installing. Refer to FRONT BRAKE CALIPER PISTON, REMOVING AND INSTALLING .
- 10 -
Seal
- Coat with Assembly Paste G 052 150 A2.
- 11 -
Brake Carrier
- The four retaining pins for the brake pads on the brake carrier must not be loosened under any circumstances.
- 12 -
Bolt
- 196 Nm