Rear Brake Caliper Piston, Removing And Installing: Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Torque Wrench 1331 5-50NmVAG1331
Piston Resetting ToolT10145
Trim removal Wedge 3409
Vehicle Diagnostic Tester

The brake caliper is removed.
Refer to REAR BRAKE CALIPER, REPLACING

-- Connect the Vehicle Diagnostic Tester to the vehicle data link connector with the ignition switched off.

NOTE:

Switch the ignition on.

The parking brake is released.

Coding check and reported if necessary.

DTC memory interrogated, errors shown corrected and DTC memory erased.

-- Start the program in Guided Functions.

-- Raise the vehicle.

Refer to REAR BRAKE PADS, REMOVING AND INSTALLING

-- Disconnect the brake line.

-- Remove the brake caliper from the vehicle.