LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Exterior Body Panels (Hood, Lids)) >> (55 Hood, Lids) >> Hood >> Hood Release Lever, Removing And Installing >> Operating Lever, Removing And Installing

Operating Lever, Removing And Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing Hood Release Lever
GWWA55-10711Courtesy of AUDI OF AMERICA, LLC
  1. Hood Release Lever Bracket
    • The hood release lever cover is removed.
    • The trim for the >>lower A-pillar is removed<<.
    • Remove the screws -3- and disengage the cable -1-.
  2. Clip
  3. Release Cable
    • Clip the cable bracket into the mounting bracket as shown in the magnified section of the graphic.
  4. Screws
    • 2 Nm
scientia non olet · About LEMON Manuals