Fuel Pressure Sensor -G247-, Removing And Installing: Removing
WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Danger of malfunction caused by dirt.
- Observe, refer to CLEAN WORKING CONDITIONS .
-- Remove the engine cover, refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Clean and dry off the threaded area around the fuel pressure sensor with engine or brake cleaner.
NOTE:
Clean carefully, cleaner must not enter the connector.
-- Disconnect the connector from the Fuel Pressure Sensor -G247- -arrow-.
-- Remove the Fuel Pressure Sensor -G247- using the Socket - 27 mm T40218.
NOTE:
Do not use an open-end wrench for opening or tightening.
-- Clean off dirt from fuel rail boring. Do not use mechanical tools.
Seal the hole in the fuel rail immediately with a suitable plug to prevent dirt from entering.