Overview - Intake Manifold
WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Bracket
- For the air guide pipe
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Seal
- Replace
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Intake Flap Motor -V157-
- Removing and installing, refer to INTAKE FLAP MOTOR -V157-, REMOVING AND INSTALLING .
- Seal
- Replace
- Intake Manifold
- Removing and installing, refer to INTAKE MANIFOLD, REMOVING AND INSTALLING .
- Bolt
- Tightening specification and sequence, refer to Fig 2.
- Mounting Pins
- 5 Nm
- For engine cover
- Bracket
- For the connector
- Bolt
- 4 Nm
- Wiring Guide
- Bolt
- 4 Nm
- Seals
- Replace
- Bracket
- For the EGR Cooler Switch-Over Valve -N345-
- Bolt
- 9 Nm
- Mounting Pins
- 5 Nm
- For engine cover
- Air Guide Pipe
- Bolt
- 9 Nm
- Seal
- Replace
- Screw-Type Clamp
- Tightening specification, refer to OVERVIEW - CHARGE AIR HOSE CONNECTIONS .
- Air Guide Hose
- Throttle Valve Control Module -J338-
- Removing and installing, refer to THROTTLE VALVE CONTROL MODULE -J338-, REMOVING AND INSTALLING .
- Seal
- Replace
- Pipe
- For the exhaust gas recirculation
- Bolt
- 9 Nm
- Pipe
- For the exhaust gas recirculation
- Seal
- Replace
- Screw-Type Clamp
- Tightening specification, refer to Fig 3.
-- Tighten the bolts in three steps as follows:
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1. | -1 through 4-, -arrows- | Install all the way in by hand. |
| 2. | -1 through 4- | 5 Nm in sequence shown |
| 3. | -1 through 4- and -arrows- | 9 Nm in any sequence |