Oil Pump, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the seal and O-ring.

-- Install oil pump onto the driveshaft and fasten.

-- Install the oil pan lower section, refer to Installing .

-- Fill the engine oil and check the oil level, refer to appropriate service information