Engine Oil Cooler, Removing And Installing: Installing
WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
NOTE:
Replace the seal.
Secure all hose connections with hose clamps of the same type as those equipped by the factory .
-- Check the oil level, refer to appropriate service information
NOTE:
Do not reuse used coolant.
-- Fill the coolant, refer to COOLANT, DRAINING AND FILLING => Filling .