Oil Pan Lower Section, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Risk of contaminating lubricating system and bearing.

Cover open parts of engine.

WARNING:

Danger of eye injury.

Wear protective eyewear.

-- Using rotating plastic brush, remove any remaining sealant from lower part of oil pan and upper part.

Fig 1: Cleaning Sealing Surfaces

Courtesy of AUDI OF AMERICA, LLC

-- Clean the sealing surfaces; they must be free of oil and grease.

NOTE:

Note the expiration date of the sealing compound.

Fig 2: Cut Tube Nozzle At Front Marking (Nozzle Diameter Approx. 1 Mm)

Courtesy of AUDI OF AMERICA, LLC

-- Cut the tube nozzle at the front marking (nozzle diameter: about 3 mm).

CAUTION:

The lubrication system could be plugged with excess sealant.

Do not apply sealant bead thicker than indicated.

-- Apply a sealant bead -arrow- to the clean sealing surface on the lower part of the oil pan as shown in illustration.

Fig 3: Applying Sealant Bead To Clean Sealing Surface

Courtesy of AUDI OF AMERICA, LLC

Sealant bead thickness: 3.5 mm

NOTE: Install the lower section of the oil pan within five minutes of applying the sealant.

-- Position the lower section of the oil pan and tighten the bolts, refer to Figure.

-- Fill the engine oil and check the oil level, refer to appropriate service information