Oil Pan Upper Section
WARNING: This page is about a different car, the 2015 Audi S7, 2015 Audi RS 7, 2014 Audi S7, 2014 Audi RS 7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
- O-Ring
- For Audi RS6/RS7
- Replacing
- Thermostat
- For Audi RS6/RS7
- comprised of a thermal element, spring and cover
- Locking Ring
- For the temperature regulator
- For Audi RS6/RS7
- Oil Pan Upper Section
- Removing and installing, refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
- Oil Lines
- for Audi RS6/RS7
- Bolts
- 9 Nm
- For Audi RS6/RS7
- O-Rings
- Replacing
- For Audi RS6/RS7
- O-Ring
- Replacing
- Seals
- Replacing
- O-Ring
- Replacing
- Front Engine Oil Cooler
- Removing and installing, refer to ENGINE OIL COOLER, REMOVING AND INSTALLING, FRONT .
- Change the coolant after replacing
- Bolt
- Tightening specification -item 2.
- Bolt
- 8 Nm
- Cover
- Seal
- Replacing
- Bolt
- 9 Nm
- Guide Tube
- For the oil dipstick
- O-Ring
- Replacing
- O-Ring
- Replacing
- Alignment Pin
- Seal
- Replacing
- Alignment Pins
- Bolt
- Tightening specification and sequence, refer to Fig 2.
NOTE:
Replace any bolts that were tightened with an additional turn.
-- Tighten bolts in stages as follows:
| Step | Bolts | Tightening specification/additional turn |
|---|---|---|
| 1. | -1 to 6- | Install all the way in by hand. |
| 2. | -1 to 6- | 5 Nm diagonally |
| 3. | -1 to 6- | in a diagonal sequence, turn an additional 90° |