Oil Pan Lower Section/Oil Pump
WARNING: This page is about a different car, the 2015 Audi S7, 2015 Audi RS 7, 2014 Audi S7, 2014 Audi RS 7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
- Oil Level Thermal Sensor -G266-
- Removing and installing, refer to Oil Level Thermal Sensor -G266-, REMOVING AND INSTALLING .
- Seal
- Replacing
- Bolt
- Replacing
- Tightening specification and sequence, refer to Fig 2.
- Oil Pan Lower Section
- Removing and installing, refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .
- Intake Tube
- For the oil pump
- Bolt
- 9 Nm
- O-Ring
- Replacing
- Bolt
- 8 Nm +90°
- Replacing
- Oil Pipe
- Removing and installing, refer to OIL PUMP, REMOVING AND INSTALLING .
- Bolt
- 8 Nm +90°
- Replacing
- O-Ring
- Replacing
- Seal
- Replacing
- Alignment Sleeve
- Quantity: 2
- Input Shaft
- For the coolant pump
- Seal
- Replacing
- Oil Pump
- Do not disassemble
- with relief valve
- Removing and installing, refer to OIL PUMP, REMOVING AND INSTALLING .
- Input Shaft
- For the oil pump
- Bolt
- 8 Nm +90°
- Replacing
- Seal
- Replacing
- Oil Drain Plug
- 20 Nm
- Bolt
- 9 Nm
NOTE:
Replace any bolts that were tightened with an additional turn.
-- Tighten bolts in stages as follows:
| Step | Bolts | Tightening specification/additional turn |
|---|---|---|
| 1. | -Arrows- | Install all the way in by hand. |
| 2. | -Arrows- | 8 Nm diagonally |
| 3. | -Arrows- | Tighten an additional 90° |