Drive Plate, Removing And Installing: Removing
WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Transmission removed, refer to Transmission Park Selector SwitchF305, Removing and Installing .
-- Insert the Counterhold - Flywheel 10-201 to loosen the bolts.
CAUTION:
The outer surface of the bearing flange at the drive plate could be damaged.
- Use a multipoint socket wrench with a shaft at least 40 mm long to loosen and tighten the drive plate bolts.
-- Remove the bolts, drive plate and sensor wheel.