Crankshaft, Measuring Axial Clearance: Procedure

WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Attaching Dial Indicator VAS 6079 Together With Dial Gauge Holder VW 387 To Cylinder Block

Courtesy of AUDI OF AMERICA, LLC

-- Install the Dial Gauge - 0-10 mm VAS 6079 with the Dial Gauge Holder VW 387 on the cylinder block as shown.

-- Place the dial gauge against the crankshaft counterweight.

-- Press the crankshaft against the dial gauge by hand and set the gauge to "0".

-- Press the crankshaft off the dial gauge and read the measurement.

Axial clearance:

New: 0.09 to 0.25 mm.