Pistons, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace any bolts that were tightened with an additional turn.

-- Coat the contact surfaces on the bearing shells with oil.

-- Install the piston and piston ring compressor.

Installed position:

Piston, refer to Figure.
Connecting rod, refer to Figure.

-- Install the connecting rod bearing cap according to the marking.

-- Install the oil pan upper section, refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

-- Install the cylinder head, refer to CYLINDER HEAD, REMOVING AND INSTALLING .