Drive Plate, Removing And Installing: Removing
WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.
- Transmission removed, refer to TRANSMISSION, REMOVING AND INSTALLING or TRANSMISSION, REMOVING AND INSTALLING .
-- Insert the Counter Hold Tool 10-201 to loosen the bolts.
CAUTION:
The outer surface of the bearing flange at the drive plate could be damaged.
- Use a multipoint socket wrench with a shaft at least 40 mm long to loosen and tighten the drive plate bolts.
-- Remove the bolts, drive plate and sensor wheel.