LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (3.0L - Crankshaft & Cylinder Block - Engine Code(S): CGXB & CTUA) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Vibration Damper, Removing And Installing >> Installing

Vibration Damper, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace any bolts that were tightened with an additional turn.

Installation is only possible in one position because of the offset holes.

-- Install the left front coolant pipes, refer to FRONT LEFT COOLANT PIPES, REMOVING AND INSTALLING .

-- Install the ribbed belt, refer to RIBBED BELT, REMOVING AND INSTALLING, ACCESSORY RIBBED BELT .

scientia non olet · About LEMON Manuals