Ribbed Belt, Removing And Installing, Supercharger Ribbed Belt: Installing
WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
-- Place the ribbed belt over the pulley as illustrated:
- Tensioner
- Compressor
- Idler Roller
- Vibration damper
NOTE:
When installing the ribbed belt, make sure it is seated correctly on the pulleys.
-- Start the engine and check the belt routing.