Balance Shaft, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Crankshaft Holder T40069 In Hole, Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

Secure crankshaft -1- in "TDC" position using Crankshaft Locking PinT40069.

NOTE:

The balance weights can only be positioned one way on balance shaft.

-- Install the power take-off drive chain, refer to DRIVE CHAIN BALANCE SHAFT, REMOVING AND INSTALLING .

-- Install the timing chain cover lower section, refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .

-- Install the belt pulley side sealing flange, refer to SEALING FLANGE, REMOVING AND INSTALLING, BELT PULLEY SIDE .