Drive Plate, Removing And Installing: Removing
WARNING: This page is about a different car, the 2015 Audi S7, 2015 Audi RS 7, 2014 Audi S7, 2014 Audi RS 7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
- Transmission removed, refer to TRANSMISSION, REMOVING AND INSTALLING or TRANSMISSION, REMOVING AND INSTALLING .
-- Insert the Counterhold - Flywheel 10-201 to loosen the bolts.
CAUTION:
The outer surface of the bearing flange at the drive plate could be damaged.
- Use a multipoint socket wrench with a shaft at least 40 mm long to loosen and tighten the drive plate bolts.
-- Remove the bolts and remove the drive plate.
-- Remove the Engine Speed Sensor -G28- sensor wheel