LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (4.0L - Crankshaft & Cylinder Block - Engine Code(S): CEUC & CRDB) >> 13 Crankshaft, Cylinder Block >> Crankshaft >> Sensor Wheel, Removing And Installing >> Installing

Sensor Wheel, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi S7, 2015 Audi RS 7, 2014 Audi S7, 2014 Audi RS 7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

-- Install the drive plate, refer to DRIVE PLATE, REMOVING AND INSTALLING .

-- The "combustion misfire adaptation" must be adjusted after replacing the transmission. Select 01 - Reset Combustion Misfire Adaptation  in Guided Fault Finding  see Vehicle Diagnostic Tester.

scientia non olet · About LEMON Manuals