Crankshaft, Measuring Axial Clearance
WARNING: This page is about a different car, the 2015 Audi S7, 2015 Audi RS 7, 2014 Audi S7, 2014 Audi RS 7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Dial Gauge Holder VW 387
- Dial Gauge - 0-10 mm VAS 6079
Procedure
Fig 1: Attaching Dial Indicator VAS 6079 Together With Dial Gauge Holder VW 387 To Cylinder Block And Setting Indicator Against Crankshaft Counterweight
-- Install the Dial Gauge - 0-10 mm VAS 6079 with the Dial Gauge Holder VW 387 on the cylinder block as shown in the illustration.
-- Place the dial gauge against the crankshaft counterweight.
-- Press the crankshaft against the dial gauge by hand and set the gauge to "0".
-- Press the crankshaft off the dial gauge and read the measurement.
- Axial clearance: 0.090 to 0.251 mm.