Control Position, Programming

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Adapting control position and checking headlamp basic setting is necessary if:

The lower transverse link has been removed and reinstalled or replaced
The subframe was replaced,
Installation work has been performed on the level control system sensor,
The level control system sensor has been replaced,
The level control system sensor coupling rod threaded connection was loosened at the lower transverse link.
The Level Control System Control Module -J197- was replaced.

Requirements

The vehicle must be standing on an even surface.
The vehicle may not be loaded.

The programing and control position is performed using the Vehicle Diagnostic Tester:

VAS PC

Connect Vehicle Diagnostic Tester.

-- Select Guided Functions mode.

-- Select the "34 - Level Control System Control Module" address.

-- Select "J197 - reprogram control position" and follow the instructions on the screen.

ODIS - Offboard Diagnostic Information System

Connect Vehicle Diagnostic Tester.

-- Select Diagnostic operating mode and start diagnostics.

-- Select the Control Module tab.

-- Select the "34 - Level Control System Control Module" address.

-- Select "J197 - reprogram control position" and follow the instructions on the screen.

NOTE:

If the control position was reprogrammed and if the vehicle has lane assist, then it will then be necessary to recalibrate the Camera Control Module -J852-, refer to DRIVER ASSISTANCE SYSTEMS FRONT CAMERA, CALIBRATING .

Perform the basic setting of the headlamps, refer to DIAGNOSIS AND TESTING .