Central Valve, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
The central valves are attached to the impact member under the bumper cover in the rear.
-- Remove the rear bumper cover, refer to BUMPER COVER, REMOVING AND INSTALLING .
WARNING:
Always wear safety goggles!
NOTE:
The DRC lines must be extracted before disconnecting them from the central valve, refer to DYNAMIC RIDE CONTROL (DRC), DRAINING AND FILLING .
Perform this step on both wiring harnesses on the central valve.
-- Remove the union bolts -2-.
-- Unscrew the bolts -1 and 3- and remove the central valve -4-.