Overview - Air Supply Unit
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 9 Nm
- Bracket
- Entire air supply unit to spare wheel well
- Removing and installing, refer to AIR SUPPLY UNIT WITH BRACKET, REMOVING AND INSTALLING .
- Clip
- Intake Line with Filter
- Removing and installing, refer to INTAKE LINE WITH FILTER, REMOVING AND INSTALLING .
- Air Line
- Between solenoid valve block and air supply unit
- Air lines overview -item 7- Air Line "Brown"
- For the air line connecting piece tightening specification, refer to OVERVIEW - AIR LINES .
- Line Connector
- Bracket
- Air Supply Unit with Level Control System Solenoid -N111-
- Removing and installing, refer to AIR SUPPLY UNIT, REMOVING AND INSTALLING .
- Level Control System Solenoid -N111-, Removing and Installing, refer to LEVEL CONTROL SYSTEM SOLENOID -N111-, REMOVING AND INSTALLING .
- If the air supply unit was replaced, then the Level Control System Compressor Relay -J403- must also be replaced. Installed location, refer to appropriate SYSTEM WIRING DIAGRAMS information.
- Threaded Sleeve
- 7.5 Nm
- Quantity: 4
- Spring
- Quantity: 4
- Rubber Bushing
- Quantity: 4
- Bracket
- Bolt
- 9 Nm
- Air supply unit to retainer
- Quantity: 3
- Nut
- 9 Nm
-- Tighten the nuts -arrows- to 9 Nm.
Tighten the bolts -1- to 5 Nm.